Answer / sk

100% contact between shaft and gauge.

Answer / devanesan

1.It is between bearing to bearing seat contact matching
%. it will be upto the type of the bearing.
2.midsplit surface clearence should be zero. then only the
matching plane contact will 100%.

during the design of a friction clutch what are the considerations that should be made?

1 Answers   BEL,

---

y we are used oil in the dead weight pressure tester

1 Answers  

---

which case we will find maximum pressure and flow in centrifugel pump- circular casing or volute casing.

2 Answers   ITC Infotech,

---

In Steam Turbine using superheated steam as an inlet steam, What happens if I use air in place of steam with the same parameters ? Will is work or not ?

7 Answers  

---

if you are standing on 30th floor & you asked to drink a water through straw .can you? water is in glass at the ground floor.

5 Answers  

---

What is plant load factor?

1 Answers  

---

what are the duties of a mechanical engineer in a gas power plant..?

1 Answers  

---

Does the position of a chicken egg affect the amount of weight it can withstand?

1 Answers  

---

In HVAC R22 gas are using for cooling but why oil are using & which type of it is???????/

2 Answers  

---

Can anyone explain Things gone right(TGR) and Things gone wrong(TGW) in the APQP process? preferable With example.

1 Answers  

---

What is pitch

2 Answers   Bhel, College School Exams Tests, RRB,

---

What is jet plane?

1 Answers  

---