Answer / iamdon

The normal value of delta(load/power/torque angle) is 30
degree.

This is selected so because during power swing (in case of
instability) the flactuation of delta is in the range of +/-
30 degree.This will result the range of delta in 0-60
degree.In this region(0-60)sine curve is linear.

Author:arbelectbit@yahoo.com

what is S.T?specify the range?

2 Answers  

---

will the introduction of capacitor bank parallel with the induction load reduce power consumption

4 Answers   Nokia, WAPDA Water and Power Development Authority,

---

What is thresh hold value of current?

0 Answers  

---

what are safety seals in HT line?

2 Answers  

---

1.Difference between vcb and Acb and partes. 2.Difference between STS and ATS.

2 Answers  

---

What is difference between ON delay and OFF Delay Timer?

7 Answers  

---

how system fault level is calculated?

1 Answers   HCL,

---

which is dangerous AC or DC? If so why?

4 Answers  

---

what is meant by negative half cycle

2 Answers  

---

WHAT WILL HAPPEN WHEN THE MOTOR FREQUENCY INCREASED OVER THE RATED MOTOR RPM THROUGH DRIVE?

3 Answers  

---

What is the difference between Earthing and Neutral?

13 Answers  

---

HOW DO I CALCULATE OVER LOAD RELAY & CONTACTOR IN DOL STARTER? & in dol why it is require circuit breaker?

6 Answers   DLF,

---