Why the arms of delta in a delta-wye power transmission
system are kept constant??
No Answer is Posted For this Question
Be the First to Post Answer
which bridge is used to measure frequency?
Where earth point should provided in Ships or Submirines.
what is the specific gravity of fully charged battery
assume we are put both df/dt and vector surge relay in same bus the df/dt relay setting is +5 hz an -5HZ. we want operat the vector surge relay before the df/dt how i calculate the setting of the vector surge relay.
Why earthing is required, and what effect in earthing result is more than 5 ohm and less than 5 or equal to 0 ohm
why permanent magnet generator have higher frequency of 400hz
how to control the generator output voltage? what r the condition should satisfy for synchronization?
is EEE eligible for getting electrical supervisor certificate ? if yes then from which state i sud apply
what is excitor response of an excitor?
What is a captive power plant?
what is closing resistor in circuit breaker? why it used?
where to use 3.5 core and 4 core cables, will this vary for type of loads
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)