What should be value of Circuit breaker operating time and
tripping
time?
Answers were Sorted based on User's Feedback
Answer / sunil solanki
circuit breaker operating time & tripping time should be in
ms.also tripping time should be less than operating time.
Is This Answer Correct ? | 5 Yes | 0 No |
Answer / barkha thakur
Circuit breaker operating time & tripping time should be
few cycles of the supply voltage
Is This Answer Correct ? | 2 Yes | 0 No |
Answer / electrix
Cicuit Breaker Opening / Closing time are always in milli
secs. usually in 11 kv breakers it is around 60 - 80 ms for
closing and 40 - 60 ms for opening.
Is This Answer Correct ? | 1 Yes | 1 No |
what is difference between armoured cable and un armoured cable
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
Why we Do not connect the windings of the motor in delta? & what would happen if we do that? I mean the winding themselves not the three lines that are coming to the motor?
What is the result of under frequency to the system.
where the lexical paramater will use in fron end?
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
what happened when we supply a dc current in dc motor?? can it worked properly?
whats the necessary to correct the power factor using capacitive banks in industries?
plz send me the placement interview question and answers of whizchip(technical and apttitude)..i have an interview in next.
I want to design a heating coil of 80/20 nicrome for 3.5KW please give me the calculations choosing for physical dimensions assume coil voltage will be 110V AC assume necessary conditions
Show Details FROM:Muhammed Ikram TO:qa@allinterview.com Message flagged Saturday, June 4, 2011 10:07 PMMessage bodyHello all, i want to ask a question to all of you that what is VMM (voltage monitoring module )? how it work,s? i heard somewhere that it compare 1 phase voltage to other phase voltage. but there is also some setting on it. how to set it,s setting. please tell me briefly. Thank,s and Regard,s. Muhammed Ikram.
What is CRT (Contact Resistance Test) for Isolators or Dis- connector Switches? Why we performed it & whats the Testing procedure.