what is caskading in networking.and how it implement ?

Question Posted / sureshpant_1802@yahoo.com

3 Answers
7153 Views
CMC, TCS, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what is caskading in networking.and how it implement ?..

Answer / rajiv

cascading is nothing but interfacing one computer output as
input to the other computer.Like this we can connect
different computers in our workplace.this can be done with
a LOCAL AREA CONNECTION (LAN).with LAN we can access other
computer's information and vice versa.for all these to
happen we require a SERVER.

Is This Answer Correct ?

7 Yes

0 No

what is caskading in networking.and how it implement ?..

Answer / guest

caskading in networking is connecting many computers at one
place.it can be implemented as 1 computers output to 2nd
computer input, and 2nd computers output to 3rd computer
input and so on.

Is This Answer Correct ?

2 Yes

1 No

what is caskading in networking.and how it implement ?..

Answer / siva subrahmanyam

Cascading in Networks means.. connecting one network to the
other network. Thye other one can be either same network or
other one.. For connection between same networks we use
Bridges and For connection between two differebt networks
we use Application Gate ways..

Is This Answer Correct ?

1 Yes

2 No

Post New Answer

More Electronics Communications Interview Questions

Why the degree of valve plugs and valve seat is slightly different I control valve trim design

0 Answers

what is the diff btw address and memory location?

3 Answers

Explain we take the area of collector wide comparison to base and emitter. Why?

0 Answers

What is simulator programme?

0 Answers

In the case of baseband signaling, the received waveforms are already in a pulse-like form. Why then, is a demodulator (receiving filter) needed to recover the pulse waveform?

0 Answers

What is the effect of if in radio receiver?

0 Answers

temperature transmitter range o to 100c over range set value 21.6ma if you give source on the field transmitter showing iop out put also 21.6ma but dcs not showing iop samething if you simulat from hart 21.6ma in dcs showing iop how its possible?

0 Answers

What is half duplex transmission?

0 Answers

What is dma controller?

0 Answers

Describe the working of 1φ fully controlled bridge converter in the rectifying mode and inversion mode. And derive the expressions for average output voltage and rms output voltage?

0 Answers

Explain to find conductivity?

0 Answers

Typically, an IA has an external resistor used for A Establishing the output impedance B Setting the voltage gain C Setting the current gain D Interfacing with an instrument

0 Answers

For more Electronics Communications Interview Questions Click Here