What is the difference between lap splice length and
development length of rebars?
Answers were Sorted based on User's Feedback
Answer / sjtbehera
Lap splice length is recquired to transfer force from one
bar to another bar.
Devolpment length is embadded lenght of reinforcement
recquired to develop the design sterngth of the
reinforcement.
Is This Answer Correct ? | 68 Yes | 2 No |
Answer / aung
lap splice is the length require to transfer stress in
reinforcement and development length is the additional
length required to get enough bond strength between steel
and concrete.
Is This Answer Correct ? | 39 Yes | 3 No |
Answer / c.kumar
Splice length is required prior to transfer the load from one bar to another bar and also to minimize the Bending Moment but the develoment length is added to reinforcement in order increase the R.C.C design and bonding strength b/w steel & concrete.
Is This Answer Correct ? | 3 Yes | 0 No |
Answer / kamlesh chauhan
both the words technically same,only usage is different.
Is This Answer Correct ? | 10 Yes | 38 No |
How many kilograms of sand required in cufic feet for one cubic meter of M25 grade concrete
How much quantity water should be placed in one cubic meter area?
in one SQM plaster how much Cement and sand consumed in ratio 1:4
1) what is the use of pin and plate vibrators during slab casting? 2) how much cement bags are required for 1sqm 4inch brick wall? 3) Is it viable to provide overlap at column , beam & slab junction. if no why? 4) if bar dia is changing in column reinforcement , which dia bars overlap is considered? 5) what is isolated and ecentric footing?
What is the formulae of percentage of steel
In which year onward limit state method used in india...
Required amount of Steel bars, cement/ square feet for roofing of residential building upto 3rd floor.
how much water you will add to the mix, for making 1 m3 of concrete to achieve strength of mix 20N/mm2 at 28 days.
how much bentonite powder mix in 1000ltr fresh water with detail.
How to calculate the capacity of Water tank?
What will be the maximum length of RCC Lintels?
What is the roll of face bars in beams