If a contactor need to replace with faulty one. what I want
to check?
- 2 Answers
- 3337 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / suga priya
simple multimeter is used to check for failure. The coil can become shorted, grounded, or open. The coil can become shorted when the insulation between the wires in the coil breaks down. This can be found by shutting off the power and taking a resistance reading between the terminals on the coil. The reading should be around 20 ohms, if it is significantly less, the contactor should be replaced
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is polar plot?
5.WHICH TYPE WELDING PROCESSES USES NON CONSUMABLE ELECTRODE.........
How to choose the vector group for the step up and step down transformers??? Tell me the which vector group is suitable for step up and step down transformers and whats the reason to choose and whats the benefits???
how external lighting design? please give examples?
What does the term power factor shows?
Battery is a voltage source? give one example of current source and why?
what is the difference between fault current ant short circuit current?
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
State angle criterion.
what will be the effect if you were using different brands of outlets?
can any one tell me about the Extra low voltage systems?From where we give supply to these type of systems??
How many types of circuit loads are there in a common electrical circuit?
what is the question paper model for section engineer in RRB
Why we use auxillary relay ? what is function of differential relay, directional o/c relay?
I want to know the 'Test voltage' for Tandelta testing of 3.3 / 6.6 / 11 KV Motors. Please explain
