what is the response time of relays when a FAULT OCCURS IN A POWER SYSTEM?

what is the response time of relays when a FAULT OCCURS IN A
POWER SYSTEM?

Question Posted / agavnn

2 Answers
5309 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what is the response time of relays when a FAULT OCCURS IN A POWER SYSTEM?..

Answer / k.prakashchandra

As per discriminative time settings

Is This Answer Correct ?

0 Yes

0 No

what is the response time of relays when a FAULT OCCURS IN A POWER SYSTEM?..

Answer / karthi

Its depends on the selected relay charecterstics . normally
it will take 15 to 30 ms .

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

What will happen if we give 220v supply on both sides to the bulb

7 Answers Exide, Sumeet Industries, Toshiba,

why does the time taken for fuse to melt is longer as the wire length increases?

1 Answers

It is observed that AVR of an Alternator is more likely to fail if the Generator and Mains Neutral are directly connected to each other. Why should this be so?

1 Answers

WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?

0 Answers

what is the difference between a hooter and a mcp

2 Answers

how rated the neutral voltage of transformer and reactor, e.g. 400/220, 200MVA transformer have neutral voltage of 33kv. and reactor voltage 145kv. how this rating decided?

1 Answers MEIL,

What are armoured cables?

2 Answers IOCL,

Why do we apply both Differential and REF (HV and LV) protection schemes on YNyn configuration of a transformer?

0 Answers WCC,

Motor and transformer working with same principle so why motor rotates while transformer not?

7 Answers

Dear Sirs, I am a technical persons.In one of our Electrical Sub- Station, We have installed three numbers of 1250KVA ,11KV/0.415KV Transformer to feed the Factory load. We have found some abnormality. In one of our Transformers the leakeage current from transformer body to earth through earth continuity wire is almost 86 Amp but in other transformer it is (5-10)Amp. where the load current on three phase and neutral are respectively 1360Amp,1400Amp,1370 Amp & 176Amp. So please any technical person help me about the reasons of this situation and how I can rectify the fault. Moreover,I have measured the earth resistance of the Earth continuity wire which is less than 1 Ohm. Thanks Tapas Barua

3 Answers

how we select the fuse and OLR rating for 3 phase induction motor from 1HP TO 100 HP?

2 Answers Thermax,

what is ALF and ISF in current transformer?

1 Answers

For more Electrical Engineering Interview Questions Click Here