What happens with squirrel induction machines if the ends of rotor conductors a

What happens with squirrel induction machines if the ends of
rotor conductors are kept open? Explain

Question Posted / dejeafrem

3 Answers
4696 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What happens with squirrel induction machines if the ends of rotor conductors are kept open? Explai..

Answer / manas ranjan mohanty

emf will devloped in rotor due to faraday's laws of
electomagnetic induction.but due to open in rotor circuit
no current will flow and so no torque devloped,so rotor
will not rotate.

Is This Answer Correct ?

6 Yes

0 No

What happens with squirrel induction machines if the ends of rotor conductors are kept open? Explai..

Answer / syed qaiser hasnain

No current will flow in the rotor and motor will not rotate.

Is This Answer Correct ?

4 Yes

1 No

What happens with squirrel induction machines if the ends of rotor conductors are kept open? Explai..

Answer / vishal singh

Due to Faraday law,emf will be induced in rotor circuit.but for current flowing,closed circuit is required.if rotor circuit will be open then no current flow in rotor circuit,due to this no torque produce in rotor.rotor will not move.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?

0 Answers Danieli,

Factory acceptance test. FAT. For 132 kv transmisstion towers what is that meaning and what are the tests commonly companies perform now days.

0 Answers PKR,

how meger function

0 Answers

why we used capacitor in induction motor?

4 Answers Mitsubishi,

Why not connect relay Y phase for over current and earth fault

1 Answers HB,

If we have to find the inductance of a dc shunt motor then by giving dc supply or ac supply and what is the reason for it. (this example is from "to determine the transfer function of a dc shunt motor ")

0 Answers

we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer

0 Answers

What, in the construction of a transformer, controls KVA? For example 600/208/120 V transformer can be 10kVA or 45kVA!!! What do we change in the construction of a Transformer in order to change the rating but not the voltage.

1 Answers

what is the use of Reactive power

2 Answers

what is the different between bus section and bus coupler

2 Answers

WHAT KIND OF LIGHTENING PROTECTION SCHEMS CAN BE ADOPTED FOR THE FLAT ROOF OF BIG DIMENSION.

0 Answers

what could be the possible reasons for copper cable to have low insualation?

1 Answers

For more Electrical Engineering Interview Questions Click Here