What is an Economizer?
Answers were Sorted based on User's Feedback
Answer / deep chand bharti
economiser is an accessory which is used to use the exhaust heat to heat the input water in the boiler. it increase the boiler efficiency and thats why why economy, so it is called economiser
Is This Answer Correct ? | 14 Yes | 0 No |
Answer / ravikumar bp
econoimiser is an acessaries of Boiler to improve the
boiler efficiency
Is This Answer Correct ? | 11 Yes | 0 No |
Answer / hardik085gmdc
As the name indicate that economizer is a economical boiler part which taken heat form the second pass of the boiler it is located at bottom of second pass which give sensible heat to water so load of evaporated is decreased and fuel is also decreased.....
Is This Answer Correct ? | 4 Yes | 0 No |
Answer / ravikumar
Feed Water Preheating using Economiser.
For an older shell boiler, with a flue gas exit
temperature of 260oC, an economizer could be used to reduce
it to 200oC, Increase in overall thermal efficiency would
be in the order of 3%.
Condensing economizer(N.Gas) Flue gas reduction up to 65oC.
6oC raise in feed water temperature, by
economiser/condensate recovery, corresponds to a 1% saving
in fuel consumption
Is This Answer Correct ? | 3 Yes | 5 No |
• Do you have any blind spots?
what is strain
I am BITS Pilani , Mechanical Engineering graduate, with aggregate 55%........and since most of the top PSU's have 60% eligibility criteria, I don't know what to do.... Is there no way I could apply in PSUs like, NTPC, ONGC, BPCL etc ever? please reply guys!!!
HOW IRON AND PLASTIC CAN BE WELDED?
Give the different ways of detecting leaking refrigerants?
When effect of variations in specific heats is considered then how do maximum temperature and pressure vary compared to air standard cycle ?
define piston
Can we achieve condenser vaccume more than 1 bar?
Q. what @the interview exact Q&A is it correct
what is the working principle of a vibration meter?
Why do we use compressor in pumps for pumping water through borewells? Submersible pump is enough then why do we go for this method?
what is natural frequency and how to find it?