Answer / narendra parundiya

both practical and theoretical is essential but more
concentration should be given to practical. read theory for
getting idea about things and do practical to analyst that
thing.

Answer / guest

Practical.

Answer / deepak kumar

practical study is more benificial for mechanical engg.
students beacause practical study clear every confusion
regarding theory .

Answer / sangamesh gaded

both Theoretical and Practical simultaneously is required..

Answer / ajoy kumar

In every field of science, Theoretical knowledge is essential to understand the subject clearly. Thereafter we can go for the application i.e Practical. All inventions in this world are only because of the application of theory into practical. Hence these are two eyes. ok

Answer / avantika bhaskar

Practical Study is always more benificial in all streams
not only for mechanical.

what is milling and types of milling?what is drilling and types of drilling? what is tapering and their types?

0 Answers   IOCL, TVS,

When flow is supersonic then the converging and diverging passage is respectively known as??????

4 Answers   BPCL Bharat Petroleum, HPCL, Reliance,

draw p-v dia distingshing naturally aspirated and supercharged engine with reference to pumping loss?

0 Answers   L&T,

Categories >> Engineering >> Mechanical Engineering Suggest New Category Question Asked @ Answers Views select what is advantage of hllow shaft over solid shaft aprt from material saving? does hollow shaft absorb more vibration than solid shaft? 0 5 wat is the meaning of cop of wet suction and dry suction????? 1 171 What is the difference between an axle and a shaft? reply soon frnds........ 4 260 16 inch = 1 ______________? 2 124 What are the steps taken in troubleshooting of a machine e.g extruder ME 0 26 What is a seal? ME 3 133 what is the mean of b.tech? 3 167 what type of pump 2 63 what is differance between ball screw and lead screw ? Amtek 1 86 What is the units of surface tension and also dimensional formula? RRB 3 218 What is meant by cigarcone? RRB 3 120 I want to know flow rate,max pressure drop,heat load,design pressure,test presurre,temp both inlet and outlet of coldside and hot side of 1,2,3,5,5.5,7.5,10,12,15 tons 0 24 why steam power plant is more popular than gas turbine plant? ME 3 304 what is EEE in thermodynamics????? ME 2 223 what is the practical use of ENTROPY? JSW 4 282

1 Answers  

What is the temperature at which diesel normally boils?

0 Answers   John Deere,

what is the effect of steam turbine control valve throtting in turbine efficiency.

3 Answers  

In a Waste heat recovery boiler feed control valve is after the economiser where as in auxilary boiler feed control valve is given before the economiser.why?

2 Answers  

what is the difference between BSP, BSW, NPT & G Threads. How can I identify them from a given component.

6 Answers  

why does cycle rim dont bend even in heavy loads???????

7 Answers   Nissan,

what is pulverisation

3 Answers   NHPC,

workingh principle of valve timing chart for cummins engine

0 Answers  

What's the difference between absolute vibration & relevant vibration regarding Boiler Feedwater Pump ?

0 Answers