Answer / bala.a

Mr. Virendra this formula is applicable for busbar only
not for cables . as per your statment 10 sq mm cu cable
suitable for 16 A only . PLEASE GO AND CHECK with cable
manufacture catalouge. the 10 sq mm Al cable suitable for
+_ 40A .

Answer / amarnath

As per standards for Aluminium cable 1sq.mm can carry 1A.
and in case of Copper cable 1 sq.mm can carry 4A.

If theres any formula to calculate please do let me know as
well....

Answer / anilkumar

As per standred there is no formula, its only depend on
cable manufacture cataloge and we following same as what
amarnath said AL cable current carrying 1A per SQMM and
copper cable carring 4A per SQMM.

Answer / murugadoss.a

Dear all please consider the length of the cable and voltage droup. Depends on the size the resistance value should be varies. For 3 phase 3.2% valtage droup allowed and 1 phase system 2.5% valtage droup alowed. before going to select the cable size to consider these all.

Answer / virendra

current carring capacity might gets slight change dependign
upon the manufacture. but in coomon practice as amarnath
said Aluminus takes 1A per sq.mm but for Copper it is 1.6 /
sq.mm

what is the harmonics? which harmonics(fundamental and reference) is suitable for calculating capacitor bank and Active filter and passive filter? what is the 1st 2nd 3rd 4th 5th harmonics and effects?

1 Answers  

can we connect both delta and star to the transformer secondary and for what reason?

5 Answers   Power Grid,

Why are lt windings placed near the core?

0 Answers  

Draw the circuit of clapp oscillator?

0 Answers  

Dear sir, please tell me how many day use CTPT transformer

1 Answers   Daya Engineering Works,

if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current

0 Answers  

I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME

0 Answers  

What are the material used for resistor?

0 Answers  

What will happened. if we feed 3phase supplay to the stater with out insert the rotor. How much current will flow through the stater winnding?

2 Answers  

How to calculate % Impedence?

3 Answers   ISRO,

WHAT IS MEANT BY SYNCHRONISING IN GENSETS

5 Answers  

I got shortlisted in RRB thiruvananthapuram for the post of Junior Electrical engineer, waiting List - 7. i want to know about the validity of the current list and chance to get the job please help anybody knws abt it,, thank you

1 Answers