Answer Posted / murugadoss.a
Dear all please consider the length of the cable and voltage droup. Depends on the size the resistance value should be varies. For 3 phase 3.2% valtage droup allowed and 1 phase system 2.5% valtage droup alowed. before going to select the cable size to consider these all.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Phase control and integral control are used for?
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
How to calculat the ratio of HT\LT in energy meter
what is difference between 2 pole structure and 4 pole structure in transformer yard
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
Batteries. What is the difference between Lead and Nickel batteries ?
does a DG set has low fault level as compared to that of a transformer.If yes then why.
what happens to the supply voltage if there is any change in frequency?
what are the applications of PLC?
Why to keep capacitor bank off while generator running.
What is the difference between a 3 winding and 2 winding Potential Transformer
What is servo motor and what are different types of servo motor
what is RFCT and Insulgard Relay & It's function?
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
How Can You Relate Power Engineering With Electrical Engineering?