Answer / srinivasan

rear engine is more efficient .. coz wen accelerating the
weight tends to shift to d rear part so placing the enginer
der will result in btr traction for the driving wheels ..

Answer / prakash c

A bus having engine at front... bec pulling has less
friction than pushing a body.. a front engine pulls the bus
where as back engine push the bus...

Answer / siddaraju v

it depends on weather front wheel drive or rear wheel drive
vehicle.
for front wheel drive vehicle placing the engine at front
is more efficient, coz it will avoid transmission losses.
and same thing for rear wheel drive vehicle.

Answer / nikhil

i think a volvo bus with REAR engine and FRONT wheel drive would have better performance,, but cooling of engine and efficiency(transmission losses) would be affected to some extent...front wheel drive results in pulling the vehicle ,,hence fricton is less..and due to engine load on rear side the rear wheels have a greater road grip to push the vehicle...

Answer / vivek

I think front engine becoz it will have better cooling
effect so increasing efficiency.
Also at the time of initial traction whole weight is on rear
wheel so it may lift front part.

What causes cylinder liner-wear down?

0 Answers   RRB,

what exactly 3by2 directional control valve means and how direction control valves work can any one explain me the diagrm please i need it must and should

1 Answers   Essar,

What is fuel ratio ?

0 Answers  

i want some quiz question on auto mobile can someone suggest any website for this

0 Answers  

what are the advantages of PID controllers compared with those of a PLC

2 Answers   Bhel,

What is the bearing number for 17x37x14 size bearing

1 Answers   BPCL Bharat Petroleum, Tata Sponge Iron,

In case of AHU ,how to arrive at chilled water USGPM of the AHU in case the AHU CFM is given. Can some HVAC genius please advise.

3 Answers   SR,

what is the reason if a supply air grill located top of the glass and glass is getting sweated.become like mist.

0 Answers   Carrier, Sail,

i want to know about Chandigarh railway application form which filled in jan 2009, its exam has done or not ? Plz tell me anybody on my mail address getravisoon@gmail.com

1 Answers  

IN THERMAL POWER PLANT WHY WE ARE USING SINGLE SHAFT FOR THE COUPLING OF HP,IP&LOW PRESSURE TURBINES....WE CAN USE INDIVIDUAL SHAFT FOR EACH TURBINE....?

2 Answers  

What is the Self & starter? what does it do in the in Genset

0 Answers   TVS,

What is knurling?

0 Answers