Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
1604Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
1614We have a distribution transformer of 750KVA/11kv/440v and an AVR (Servo Stabilizer) of 750KVA on the LT side of distribution transformer. Also we have an ACB of 1200A on the output of distribution transformer (that is on the input of AVR). We want to have an MCCB on the output of AVR. What should be the rating?
SSPL,
2045can we replace Dyn11 transformer to Yy0 transformer and what is the difference between the two type
1 2738Post New Electrical Engineering Questions
How harmonic block test are conducted on relays ( Siemens,Areva ect )power transformer using omicron kit?
Why we are going for converter transformers for DC drives application instead of distribution transformer?
What is MS-EXCELL?
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
What is meaning of out of phase (making & breaking) capacity And how to calculate
11 kV line deraction check by an Engineer.
How a capacitor discharge weld power supply works? what is the use of a pulse transformer?
how could we calculate the no of outgoings from a 800 watt distribution board
what is mean by restructuring power system?
CT Ratio of a energy meter connection is Red Phase : 100/5A, yello Phase : 50/5A & Blue phase : 100/5 A what is the overall Multiplication factor
What is the use of iron core in a transformer?
How to Calculate The Neutral Earth flat design calculation for the Synchronised generator (Gen 1-650Kva, Gen 2-725Kva
In synchronous motor, how the field current is related to armature current..i know its inversely proportional..but concept wise...i was nt clear....pls help me...
What difference between ref protection and differential protection ?
transformer phasor diagram under load explain it?