When both contractor star & delta is hold in star delta motor ?? So what happen in this case ??
1 2422if flux and load static in dc motor and supply voltage increases 20% then what happened in speed
1906Shall we use Dyn1 transformer in place of Dyn11 for motor application as a distribution transformer
1 2918From reading, Under voltage relay used also as phase sequence relay now, Why I use under voltage and phase sequence relay in the same circuit (ATS)?
1786What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
2659In what situations relays are used in Circuit breaker? In Above what rating of Circuit breaker the relays are used? Why relays are not used for CB like MCB?
1733How relay coordination has to be done? what are the inputs are required for this? Please explain this with calculation method?
1827Now I inject 1kv DC supply r&y=??? R&Y=?? Y&B=?? B&R=???? RYB&N=??? RYBN&E=????? Minimum value====???????
1 3101What will happen if the rotor circuit of a slipring I.M. is kept open & electric supply is given to its stator winding.
2 7353Post New Electrical Engineering Questions
design a 3 bit synchronous and asynchronous counter using T- flipflop
what is formula for calculate thermal overload in new numiricalrelay( not in bimetal relay)?
what is the difference between circular wdg & ractangular wdg?
how to test and calculat the head and discharge in borewell compressor
what is interpose? where it is used and why it is used?
WHAT IS DIFFERENCE BETWEEN MANUAL CONTROL AND MAGNETIC CONTROL AND STATE ITS ADVANTAGE /DISADVANTAGE
how to calculate fault level?
what is DRP panels?
Explain what is rated speed?
witch pump used in wtp
what is the advantages of having in-built acvvvf (without seperate inverter in the control panel)in the drive system of elevators?
WHAT KIND OF LIGHTENING PROTECTION SCHEMS CAN BE ADOPTED FOR THE FLAT ROOF OF BIG DIMENSION.
Difference between ac parallel circuit and ac series circuit?
how electical engineer is related to apsrtc (general) post? if they ask a question in interview as why did u choose this job what shd be answer
can anyone show me how the 3 phase power is supplied to socket outlets?