using in R,Y& B PHASE LTSIDE(415V)ct ratio 4000/5 WITH ENERGYMETR OF 1280 REV./KWH,240V.WHAT WILL BE MF OF METRE.
HCC,
1 3191a induction motar has 30-35% exciting current at no load but in transformer it is only 2-3% ofbrated current why any reason?
1 3544in short circuit. test of a transformer 5 to 10% ofvrated voltage is used why??? if we use rated voltafe then what will be?
1 3133in an open circuit. test there is no load curent.. but secondary. ia open then no urrent have to flow but there a smaller current flows why?
4 6371How i can select current transformer and meters for the upgrading the panal..for 200kw to 600kw....i need to select monitoring and protection ct,s and apmpire meter ,kw meter too.
1 3447Post New Electrical Engineering Questions
power transmission pole used one support , that only for support or earthing
What is thresh hold value of current?
I am a electrical engg. diploma holder,applied for junior engineer (electrical),Kolkata RRB. Have I to attend all electrical,mechanical&civil portion in written exam.???
what is the voltage between earth to neutral in lift.
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
How to know any size of cable if there are not written on cable? Answer must be theurical not by experience.
what types of cable used in underground coal mining?
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
what could be the RMS value and average value of a 4 phase sine wave?
During underground cabling in landscape area what did we cover the cable with to prevent the electric shock & protect the cable?
before synchronizing an alternator,power factor is leading ,why?
write circuit diagram for a motor rotate in forward direction once it started and when pressed the same button it should rotate in anticlockwise.
Explain difference between stand by earth fault and residual earth fault protection?
Operation carried out in thermal power stations?