what is the difference between series and shunt compensation using facts in a transmission line
8 41236Suppose i Have an Ac motor of 25Hp 1500 Rpm 50 Hz Can i run a motor 2500 Rpm by AC drives by increasing a frequency either it safe or not ....
2 30001 KVAR = 1.3Amps but, 25KVAR capacitor/690V capacitor takes just 21Amps as leading current, what is the reason? Please explain...
1 7005You are given 220 V supply source, four wires, an ammeter and voltmeter. There is no any indication or description on meters. How will you identify which is ammeter or voltmeter?
ABB,
7 8008If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
MEIL,
1313IN CABLE TRENCH WHY FILL UP THE SAND. AND WHAT IS THE DIFFERENCE BETWEEN OVER HEAD AND UNDER GROUND LAYING THE CABLES
2 11687How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance
1307X is a uniformly distributed random variable that takes values betweeen 0 and 1.The value of E {X3}(x cube) will be.
GATE,
1 2395If the rank of a (5x6)matrix Q is 4, then which one of the following statements is correct ?
GATE,
1 3304An input device is interfaced with Intel 8085A microprocessor as memory mapped I/O.The address of the device is 2500H.In order to input data from the device to accumulator,the sequence of instruction will be
GATE,
1 5205Post New Electrical Engineering Questions
I want to know Electrical Circuit?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
state basic meaning of 'INDUSTIAL AUTOMATION'?
what is thermal resistance of PVC Cable.
for 4 MVA , 33K.V/6.6K.V transformer. secondary side the connected load is 3000H.P. What is the rating of capacitor bank to be insttaled.
What is the basic of DTH.
can some one clearly explain why -48 volt DC use in telecom site????
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
Why reactors use before incoming of ac vvfd drive?
what is auto re-closer?
WHY L-G FAULT IS MORE SEVERE IN TERMS OF RRRV?
In motors how many types of cooling systems were used?
TO CALCULATE THE RESISTANCE OF GRR OF HT MOTOR 400KW WHEREAS STATOR VOLTAGE 6.6KV AND ROTOR VOLTAGE 705V AND ROTOR CURRENT IS 346A.
What is frantic effect?
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?