Interested to Buy Any Domain ? << Click Here >> for more details...
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
1920i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
1954Post New Electrical Engineering Questions
what is rating boiler
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
What is trip and closing coil in cb? Why need of them
what is load vs Torque curve & why it is used?
How does PLC work for sychronising of Two or more DG sets?
How to Prepare preventive maintenance shedule of machine tool.
what happens to the supply voltage if there is any change in frequency?
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
please tell me how a surge protector work on a DC 48Volt.? please describe briefly.
how to carried out tan delta test in 11 KV alternator ?
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
