Why converter duty transformer neutrals are not earthed...i am still not sure if this question is also correct...Please email at ranjan120482@gmail.com
2339How to decide the rating of CBCT? We have 6.6Kv switchgear & having 50/1 cbct ,i want to know how this 50/1 A came? On what basis we decide CBCT reting?
1 8767What is difference between Step Up Transformer & Booster Transformer? can we used instead of any one?
CS,
2 17563Difference Between Differential Relay and Restricted Earth Fault Relay of Power Transformers
KSEB,
1 11460can anybody send me syllabus of rrb section engg (electrical). and also send previous question pepar...
GKB,
1985hi can any body send me syllabus of rrb electrical section engg... and past pepar also of any board...
2684If there is no problem with the electronic circuit and regulator then why the motor start rotating at low value of regulator with full speed both at laod and no load??? and if my judgement of circuit is wrong then what is your openion?
1 2769If a motor of 8.5 KW with same load and using in both Star & Delta one by one,then which will take more current in star connected or in delta connected
4 9288Post New Electrical Engineering Questions
Is there any Institution for giving M-tech in Electrical engineering for those who r in service? Give the details please.
Which type of questions well asked. ?
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
how tto ingress mw in turbine explain.procedure ?
Is there chopping current in resistive circuit
How many sprinklers should be in one pipe line?
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
WHAT IS ELECTRICAL MAINTAINTENCE ?
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
What does the term supermesh means?
which VFD is better ( LT or HT)
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
Purpose of providing neutral isolation panel for parallel operation of diesel generator
An automatic water heater is an example of which type of control system?
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .