IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
2079what is the range of thermal overload and over current. Answer should be in percentage of current.
RMSI,
2276when two gen set runing in parallel but thay have diffrent pole pitch, then what will be happan
1968what is the reason of current flow in nutral although load is balanced (three phase equal current)
3 5996How to calculate the cable size (XLPE)for suitable to 120KW load (if Motor or heaters etc)
SSC,
4 16174WHAT WILL BE THE SPEED OF MOTOR IF NO.OF POLES ON STATOR ARE NOT EQUAL TO NO. OF POLES ON ROTOR.???
4 7744Post New Electrical Engineering Questions
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
What are the different losses In a de mac1une'! t.xplam
What is time response of the control system?
sir, I am from EEE branch.On feb 17 iam going to write an Exam for hindustan petrolium corporation Ltd.So plz send me the written exam pattern/Q's/interview questions.please mail to eee_dharmendra@yahoo.com
what is lrs tank water resistance.
how to estimate wiring ins roughing ins. and boxes
Describe the control mechanism of missile launcher???
why we are using earth pit in sub stations.?
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
what is a synchronizing lamp ?
What cmos is and its benefits?
What is the Surge for 1.1 Phase Induction Motor(For Eg.1Hp) 2.3 Phase Induction Motor(For Eg.1Hp) 3.AirConditioner(For Eg 1Ton) 4.Refrigerator(For Eg 180Ltr or 160kW) 5.Induction Cooker 4. Ceiling Fan
sir iam from electrical and electronics branch ,can i appear for the hpcl offline requirtment? if yes please mail me on vikram_raju25@yahoo.co.in
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?