For polarity test on a 11/3.3kV 2.5MVA delta-star Unit Auxiliary transformer,415V 3-phase supply was applied at the HV. Connection between Aa was made with a 2.5mm cable. As soon as power was switched on the cable caught fire and burnt. This test was then abandoned. It is noteworthy to say that a similar cable was also used in a similar transformer for the same. The cable did not burn and test was successfully completed with good result. What is wrong? Please, help me out.
3 6434In the Variable Voltage Variable Frequency Drive, how the Voltage and Frequency varied ? Is it varied in the Inverter part of the Drive ? Please give us supporting document if any.
1502in our sub station why we step down firstly 33kv\11kv then 11kv to 430v. can we direct step down 33v to 430.v.
18 36348When semiconductor fuse does save thyristor in each cycle of conduction? Why under voltage setting keep less in SPRS and more in DC drive?
1625Post New Electrical Engineering Questions
Let me know that how i calculate the alternator sub tranciant reactance and tranciant reactance.
If I want to buy a new Xformer for my plant what are the main parameter will I need to check?
how to check regenerative load in drived motor
sir i applied for hpcl(electrical).i want to know from which subjects most of the technical que will b asked.and pattern of the written test.pls help me
How to check the Bushings of the transformer?
What are the advantages of speed control using thyristor?
what is buffer resistance starter.?.What is the working principle and where it is used..?
What is Electrical Grade Aluminum for Tubular BusBars. i am confused between 6063 and T6 or T5 and what is BS 2898 and BS 159?
what is mppt (maximum power point tracking ) and how they used in solar power generation ??? what are the main components used in mppt?????
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
plz tell me,ht and lt panel terminals in substations explain beiefly
how to calculate short circuit current for the busbar
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
one conductor length is L.and i am strech uniformly this conductor and made length is 2L.so resistance of this strech conductor is R=4R..but i want to know about area of stech conductor hows it become a/2..
what is meant by surge? what we called for high currents?