Interested to Buy Any Domain ? << Click Here >> for more details...
Why in power plant projects we see DOL starting method used for motors upto 160 kW instead of star delta method
UCC,
1791In a synchronous motor. if start is running at high speed. What will be the starting torque : Higher Lower Zero
1668in the farm,water tank of 8000 litter capacity situated in 12 meter above.Farm owner want to lift 7000 litter of water within 7 minute to water tank of 12 meter above.which motor having HP rating is suitable for pumping??
1 3204we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
1626We are dealer in Maharashtra State & We have recd. form C from dealer of Maharashtra State against our E-1 form. Now assessing authority is asking for counterfoil of our E-1 form. But, our E-1 form counterfoil is misplaced somewhere & assessing authority is disallowing the C form which is recd. from Maharashtra State.Please let us know the option for allowing C form?
1 2403What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
1747Post New Electrical Engineering Questions
Define cut-off rate?
what is meant by motor startup supervision & motor load jam protection ?
List out the different frequency domain specifications?
how you taken aotitude test
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
how to find the torque of the single phase synchronous motor by doing an experiment
Control cables in S's will carry 1000v which is AC R DC? Pls answer me
what is the transformer turn ratio formula and give some examples?
why zero sequence impedance measurement is not applicable for single phase GT
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
block diagram of 2 ups system connected in parallel mode?
How to calculate fault level of 11 KV system
How to calculate capacitor bank size at a load 800kVA.
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
Define phase cross over?
