As we know multiplicity factor derivation equation is as below MF = main c t ratio / main p t ratio * meter c t ratio / meter p t ratio * meter dial constant Where in digital meters for HT kwh import export now a days meter constant are calibrated already which is 1 So my question is For HT 11kv 110 v line values are as below Main c t and p t ratio are 11000 v and 110 v and 20/5 means 20 amp and 5 amp Now meter values are 11000/√3/110√3 and primary and secondary amp are displayed as -/5 amp on kwh meter so what will be the MF for this meter ?
NEPC,
1 1973what is the use of current transformer in power transformer secondary side.?its connectyed in WTI
1309Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
1125Post New Electrical Engineering Questions
What is icu and ics in Acb and how many time icu or ics passes from breaker?
How much dc volt applied in cathodic protection system?
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
sail kaott diploma ece ke interviw me qus.kis parkar ke aate hai aur G.S me kya puchate hai kya sameedyaan me kis parkar ke qu.puchate hai
what is the generator rating for 40 amp load of 3phase motor.?? 400v voltage of generator... plz tell me with formula its urgent...plzzz... and also tell me that this 40 amp at all phases mean 40 amp on red,40 amp on yellow,40 amp on blue...... or the total sum of that 3phase is 40 amp....
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
How much should be the load percentage for 15kva Inverter and Iinut & I output load with Calculations
how cables go in and come out for distribution from the feeder pillar box?
How the setting of the vector surge relay shall be calculated when the relay is to be used for Grid islanding application?
how to flameproof electrical motor on the shaft?
How can we measure the residual voltage in dc machines?
How to synchronization will be done between two DGs ?
If UG power cable both ends are to be earthed or what? If not why?
Is it possible to protect 3phase overload and earth fault of the 3phase system using two CT's.
can u describe the method used for protection of transmission line.
