Civil Engineering Interview Questions
Questions Answers Views Company eMail

In case of tunnels (Railway) what is the way of securing a wall beam?


1 2200

what is the significance of bending moment in a structure?

5 15976

how is shear resisted in a structure?

2 3529

what is the allowable silt content in concrete?

7 7888

what"s the purpose of damp proof course (DPC)and where it"ll provide?

4 23316

which size of box use of cement,sand,aggregate to use the m 20 concrete. i know the quantity of material cement 400 kg or 8 beg ,662 kg sand and 1200 kg aggregate. i can use only 1 beg cement so pls give me answer . thx in advance


4 26147


1 2276

Two types of piling

8 6571

What is IS Code ? And What is IS - 9301 ?


1 12464

What is IS ?

4 3680

what"s the formula to calculate the water for M15 grade concrete?

4 12804

What is the difference between first angle projection and third angle projection?

Nagarjuna Construction, Elecon, CLG, JTEKT,

9 41605

What is the procedure to calculate the compaction of sand?

Aditya Birla,

2 6248

How many bricks in one cubic meter? Birck size 22.9*11.4*7.6 joint 12mm Give me answer with calculations


8 21586

how is the wastage component in structural steel being considered while doing the reconcillation for the fabrication with returning of scrap under 1 meter length

NTPC, LIC, Tata Steel Limited,

4 13712

Post New Civil Engineering Questions

Un-Answered Questions { Civil Engineering }

20 mpa what is the quantity of cement sand and aggregate in one cubic meter of pcc non rainforcement concreate kindly answer including formaula thanks


With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr


How to calculate unit weight of concrete for m40 grade.


For elevated service Reservoirs what will be the output of each skilled carpenter and bar bender.


how to balance aggregate during mix design of concrete???? how to calculate moisture content like C/A,F/A and how many percentage using ice instead of water for example of we are preparing ice concrete??????


How many % we consider for lap for reinforcement for estimates


how many cement used in single story residential building per sqft


what is relation between SPT N value and driving piles after conducting a soil test?


how to create our resume?


Stringer How many cm goes to landind


Dear Sir What is the Contraction joint for base Slab


Civil engineering material testing Standard results


what is the sequence of the activities in the typical under ground water tank including civil & MEP works.


Wats the formula of eccentric footing and how was calculated from concrete qty


How to test cement,sand,20mmbluemetal,40mmbluemetal,bricks,concrete by visual and instrument