Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate cut length of re-bar in a circle . because we not place same length of re-bar in whole circle maximum in center and minimum at corner so how to calculate middle bars???
1910how to calculate weight of round steel bar and square steel bar, i section bar and c channel bar, angle bar
2 4663How much of fly ash is allowable in Portland cement and what is the disadvantage when the level of fly ash is increased?
1815Column is a compression member, concrete is strong in compression..then what is the reason to the column reinforcement..?
6 9622Post New Civil Engineering Questions
I used Etabs software to analyse a high-rise building. And I want to use templated UBC-codes inside to calculate the Seismic load. My question is: whether or not I have to control the seismic load by base shear load which is manual calculation? (just for more clarification: I can control this by input the scale factor into Eartquake definition in Etabs) I would highly appreciate your answer.
is there any codal provision for soil cousion over the Hume pipe of Dia 1.2 m.
What is the biggest dam in america?
what is escalation?how it is done?
How do we calculate absolute pressure?
What black man invented the clothes dryer?
Reinforcement details at hinged joint
For the construction project what capital cost has to be taken in consideration?
Design a reinforced concrete combined footing (rectangular) for two columns located 3.60 metres apart. The overall sizes of the columns are 40cm x 40cm and 69cm x 60cm and the loads on them are 1000 kn and 1500 kn respectively. The space available for the width of the footing is restricted to 180cm. The S.B.C. of the soil is 280 kn/mm2 use M15 concrete.
how to do cementicious paint for rcc walls of cw pump house
how many material required for brickbat water proofing of toilets.
In which code the the maximum height of concrete casting has been explained
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
While doing civil foundation of machinery. How will you process for it? & We also fixing plates at top surface of foundation, then what is the procedure?
What is bmc stands for in bmc software?
