Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) The higest value of thermal conductivity is expected for a.) Solid ice b.) Melting ice c.) Water d.) Boiling water Give the thermal conductivity value for each.
BEL,
8 28086DURING STEAM BLOWING OF PIPE LINE, A BLUISH COLOR CONICAL PATTERN IS OBSERVED AT THE END OF PIPE. WHATS THE CONCEPT BEHIND IT?
1 5440IN OLTC we observed "OUT OF STEP" Alarm, we have two different transformer, when both are in parallel this type of alarm observed. what's the meaning of this alarm and why it occurs???
3 21739How to Convert horsepower to kva? what is the three phase formula? email me if u know thanks Rehan smileavail@msn.com
3 10162
What is general pressure ratio for axial, reciprocating and centrifugal compressors?
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
what is the function of solid state relay (SSR)
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
How to Calculate Current Rating of SDFU (Switch Disconnector Fuse unit) for Protectionof Capacitor Bank connected to Busbar of 800Amp,in LV side of 11/0.433KV, 250KVA Transformer?
Instrument connected to a single phase supply
How we can change the direction of rotation of Induction motor? Prove it using graphical
What is quality management system? Weather qms is suitable, adequate and effective or not? Is there any quality policy? Is there any quality objective? If yes, then what are they? How they are planning to achieve quality objectives? Do they are measure quality objectives?
how to find rmc plant MD?
whats the application of voltage regulation? and whats the voltage regulation's device?
What is meant by counter flow heat exchanger?
The advantages of Magnetic flux leakage technique over Ultrasonic technique for non distructive testing of material.
Name any three cellulosic fibers?
Why the output of OP-AMP is always less than Vcc?
For plate load test why we are applying pressure 3 times the proposed allowable bearing pressure? Is there any supporting standards for this?