Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) PLEASE INFORM ABOUT THE IDEAL TEST RESULTS OF MAGNETIC BALANCE TEST OF TRANSFORMER 33/11 kv DELTA-STAR T/F
2210what r all the type of viberation measurement measuring in turbin? what's the output of viberation sensor?
2 7102One of our gas turbine generator unit "1st stage rotor ground fault" alarm was occured several times. we tried to measure some voltage vulue ground fault protection relay (UNS3020a made by ABB and we measured the value of: Ground: 0.9VDC 5V: 5.8VDC 24V: 23VDC u+: 300 – 350mVAC Rf1: 17.5mVAC Rf2: 17.6mVAC The unit still running and the alarm was reset. As of 6pm yesterday and unitl now no alarm happened again. I our protection relay was defective?
1 4490plz tell.. how can we find weight(in kg) of 1 cum of m20 mix..? how can we find the ratio of cement sand and agregate on site i.e if we given some amount of m20 mix then hw we find the ratio..?
7 58364A cylindrical vessel of 10m height has water upto 6m and is under a pressure of 15bar.What will be the pressure at the bottom most point of the vessel?
4 7164
What is the standard volume of pharma in cub ft
What is zero of the system?
I am completed diploma in mechanical in 2002, i have 5year experience in materials (purchase) dept,i want to do SAP cource in MM module, i want to know can i complete SAP after diploma cource only, is it usefull to me for further Job opening.
IN 1000kva transformer where the oil and winding temperature sensors is connected
Explain the difference between the points of inflexion and contraflexure?
i have want jindalsteel tecnical wrritten test paper.
How is ceramic defined ?
I am B.E.electrical engineer having 7 years of experience in Transformer testing upto 315 MVA.I want to khow how I can get the 'Electrical Valuer' License.
whou haat goals do you have in your career
i want to know some description about SIM architecture... what is inside the SIM?
I want to know Electrical Circuit?
Why we specify TNC switch with 1NO 1NC ,2NO 2NC ? how we get connection.?
what is the soft starter principle? how is connection diagram? what is the procedure for checking the connection?
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
Define What materials were used to build the Golden Gate Bridge?