Engineering Interview Questions, Answers for Freshers and Experienced asked in various Company Job Interviews

Satellite Systems Engineering (106)
Engineering AllOther (1379)

Engineering Interview Questions

Questions Answers Views Company eMail

Tell me what is race around condition in a jk flipflop? How it can be avoided?

1060

We take the area of collector wide comparison to base and emitter. Why?

1053

Explain what is the difference between inductance and resistance?

1138

Tell me can a gas be used for conducting current?

898

Explain what is the difference allen bradley and siemens plc

1098

explain the output of the lexical analyser is

3215

explain how does frequency affect the size of smps?

3172

What is the formula for power gain when input gain & output gain is given?

3669

Tell me why the shape of op-amp is triangular not other shape?

3580

Explain how to convert binary to gray code and vice-verse?

3682

How to design binary to gray code converter?

3719

How to program micro controller?

3727

Explain how to measure the insulation resistance for printed circuit boards?

3750

How to increase the gain and directivity of an antenna?

3670

Tell me what is memristor? How many modes it works? Also what is its advantage? How it differ from others & why the name evolve? & What is its uses?

3669

Un-Answered Questions { Engineering }

why dose response of a phototransistor depent upon the wave length of the incident light?

2105

What is a good relation to use for calculating tube bundle diameters?

1124

Why hydropower stations are preferred solution for meeting peak loads in grids?

1006

If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?

2083

Tell us what is binding?

Anyone answer what is average cost for 1 meter GI pipe Hot dipping

1575

draw the block diagram of fire alarm?

5422

What is a resistor?

1178

What is pre-stressed concrete?

1118

What is the function of electron gun used in crt?

1062

1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

2034

What is absolute pressure? How absolute pressure is calculated?

1139

why we can use 1 to 5V dc

1960

how to meas-our losses for L.T & H.T

2168

Explain what is reverse saturation current?

1152

For More Un-Answered { Engineering } Questions Click Here