What is the min.& max distance between two earth spikes is required for me

What is the min.& max distance between two earth spikes is
required for measuring earth resistance of an earth pit? Is
the manufacturer of Earth tester decides this? Pls explain.

Question Posted / sree

3 Answers
9551 Views
ABB, HAL, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What is the min.& max distance between two earth spikes is required for measuring earth resist..

Answer / prem devkota

the minimum and maximum distances are 5 and 10 meter in
practice. But in general manufacturer declares the distance
requirement.

Is This Answer Correct ?

14 Yes

1 No

What is the min.& max distance between two earth spikes is required for measuring earth resist..

Answer / m.hussain

distance is 5 and 10 meters in same Allignment.

Is This Answer Correct ?

0 Yes

0 No

What is the min.& max distance between two earth spikes is required for measuring earth resist..

Answer / elizabeth

The minimum and Maximum distance is zero. And manufacturer does not decide anything.

Is This Answer Correct ?

1 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?

0 Answers

in 400 kv system why should trip both side CB when we give hand trip?

1 Answers KPTCL, NHPC,

How to select the releases for MCCB ?

1 Answers

In a 3Ph induction motor(old) 6 wires came out from terminal & not mentioned u1,v1,w1,u2,v2 & w2. how can find out the terminals? how can connect to star delta starter??

1 Answers

how to find motor contactor rating and bimetalic relay rating? of 30kw motor which will operate on star-delta starter?

6 Answers HCC, L&T,

through which medium return supply given to alternator please answer in details

1 Answers MahaGenco,

why stay insulator is not used with stay wire for 11kv Lines. Whereas it is used for LT lines ?

2 Answers Essar,

what is mean by drives?

0 Answers

Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)

0 Answers

How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors

0 Answers

Explen all type electrical protection ? like O/C,E/F,NPS,VOLTAGE UN BLANCE,CURRENT UN BALANCE,NAGETIVE PHASE SEQ,AND ETC...............electrical Protection

6 Answers Reliance,

Getting nusense tripping in a 11KV soft starter, have checked all it control supply & contactors but did not get any fault please help.

3 Answers

For more Electrical Engineering Interview Questions Click Here