Is there any interfacing sofware to build communication between a PC and ER300

Is there any interfacing sofware to build communication
between a PC and ER300P model L&T make trivector meter via
RS485 port which is available in the meter and is there any
data acquisition card available to store the acquired data
from the meter into the system

Question Posted / sankarithi

12 Answers
22221 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Is there any interfacing sofware to build communication between a PC and ER300P model L&T make..

Answer / shruti

Hi, i am having ER300P meter, can anyone provide addresses from which i can read the data using RS232? It would be a great help

Thanks

Is This Answer Correct ?

0 Yes

0 No

Is there any interfacing sofware to build communication between a PC and ER300P model L&T make..

Answer / rohit

plzz anybody tell me modbus addresses for the er300p energy meter. on which modbus adress i can get voltage, current, freuency reading plzz anyboy tell me..

Is This Answer Correct ?

2 Yes

4 No

Post New Answer

More Instrumentation Interview Questions

how to calculate temp.prapotional to mv in thermocoulpe.

2 Answers Electronics, KNPC,

what is performance test.need defination

0 Answers Takreer,

how to test rotor &stator earth fault in turbine

1 Answers Bhel,

what is "smart" in smart transmitter ?

4 Answers

Why upper weighing limit of electronics balance is 90% of the total weighing capacity?

0 Answers Emcure,

Which type of diagphram use in costic line,DM water line,natural gas line,oil line?

0 Answers Hindustan Zinc,

1,why we use 4-20 ma output of all instrument qhy not use 0- 20, 2,what is the different between PLC & DCS. 3,how can we meaure maximum span of new flowmeter if not given any information.

4 Answers Reliance,

What is the minimum rating availalbe for weld neck orifice in market?

0 Answers Jindal,

yokogawa Temperature transmitter showing Error 15 which is Reverse Cal Fail (confirmation calculation result is bad) in manual they mentioned reasion That the output goes to the value set by hardware failure mode jumper. How can solve this problem ? anybody can say solution

1 Answers GTL,

Pl send the model question paper of mahagenco account officer post

0 Answers MahaGenco,

please tel me the calibration of pneumatic controler.

0 Answers

Why we are using 4-20 mA as Analog signal transmission other than 3 to 19 or 2 to 18 or 6 to 22 like wise ? What is the reason behind using 4 & 20 mA? Can anyone give proper technical reply ?

5 Answers Air Liquide,

For more Instrumentation Interview Questions Click Here