HOw To Use 24V DC in Instrument?

2 Answers  

---

you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.

0 Answers   DEWA,

---

What properties or parameters to be taken into consideration for protection while selection of Dcs controller.

1 Answers   JPL,

---

what is difference between venturi and orifice

1 Answers  

---

What is 3 selection available when configure the burnout protection for controller

0 Answers   EI Electrotechnical Institute,

---

---

1. what is 3 point calibration & 5 point calibration? 2. If we use hart communicator to set the LRV & URV of a smart transmitter, did we calibrate the transmitter? why? 3. Make a complet list if meterials needed to properly connect a pressure gauge to a steam pipe using 1/2 inch stainless steel tubing. The gauge connections is 1/2 inch NPT-M and the steam pipe tap has a 1/2 inch female coupling, compression fittings are use. 4. What are the tools in loop checking? 5. What would the ISA symbol of a square root extractor look like? 6. What would you do to completely prepare for the configuration? 7. What safety measures must you undertake when doing configuration? 8. what are the two most commonly use programming languages used when we configure a PLC? 9. What would you do if you accidentally skipped a step in the configuration procedure? 10. How would you know if the configuration were sucessful? 11. Name at least 3 selections available when we configure the burnout protection of a controller?

3 Answers   EI Electrotechnical Institute,

---

Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?

0 Answers  

---

two common seiling liquid used in seal pots are:

1 Answers   Thermax,

---

Any Transmitter Range (Span value) start from 2?

1 Answers   Exxon Mobil,

---

What is difference between Ionization heat and bimetallic heat

0 Answers   KOC,

---

In field side transmitter voltage droping here no loose connection then what will happen?

2 Answers   Edac,

---

what do you know about Foundation Fieldbus?

1 Answers   CCIE,

---