Answer / vasudeva rao

1) power factor is nothing but reactive power control. i.e
if reaactive power requirement is more in the lines then
the angle between active and apparant power changes.
2) other wise simply says cosine angle between voltage and
current

Answer / yash

The pf means suppose the pf of any induction motor is .8
it means that it has the capability of using 80% current of
the total current which reaching to that motor

can i use 2000/5A Clamp meter to measure HT cable

0 Answers   century, Engro,

---

what is through fault?

0 Answers   KSEB,

---

In 6600/√3/110/√3v voltage transformer,how much output voltage in open delta transformer,after removing 1-phase of primary side on transformer?

2 Answers  

---

what is thermal setting and magnetical setting?

1 Answers  

---

What is working principal of V.C.B., O.C.B., A.C.B & Over load relay?

4 Answers   Unitech,

---

first 3 men were there .again 3 came.total how much?

11 Answers   Wipro,

---

plzzzzzzzzz plzz send me the papers of JSPL WRITTEN TEST..SO that i can prepare for the test in electrical engg..

0 Answers  

---

what happen if we give 220 volts dc supply to d bulb r tube light?

9 Answers   NHPC,

---

What are the protections required in the main lt panel which is connected to the transformer.

1 Answers   Ispat,

---

define power quality

1 Answers  

---

can we start a 6.6kv ht motor with 415 lt supply

1 Answers  

---

Define steady state error.

0 Answers  

---