Why used in layer by layer charcoal and salt used in earth
pits.
Answers were Sorted based on User's Feedback
Answer / raj
The salt and charcoal is added in earthing pit to lower the resistivity of the soil. The salt and charcoal have good ionic behavior and reduce the soil resistance. The lower earth resistance is must to quickly pass the earth fault current to ground.
Read More:
https://www.cselectricalandelectronics.com/question/why-salt-and-charcoal-are-added-in-earthing-pit/
| Is This Answer Correct ? | 0 Yes | 0 No |
Rotor is taken away from three phase induction motor and three phase supply is given to the stator.What will happen?
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
Can we get the shock if Power system is unearth means delta type take an rated voltage as 6.6 KV?
Iwould like to know barc interview questions
anybody can give the voltage value for 1M ohm
As per BIS, Earth pit resistence value?
Define unilateral circuit?
What is the Harmonics??????????
In an alternator running with a balanced zero p.f. lagging load, phase differernc between the resultant armature flux and main field flux is always____? options is 180 degree....why?? explain.
why we maintain 50hz ,220volts,20Amp,ratings fixed every where in india,,electricity
why sec of ct should be kept shorted
does buccholz in a transformer use batteries
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)