Answer / balu

it is onlly used to verify that the system work properly

what is skin type thermocouple? how it is installed? what is the difference b/w thermocouple & skin type thermocouple? what is gounded & non-grounded thermocoplle? what is the diff b/w these two?

2 Answers   KazStroy Engineering, PSU,

---

what is the name of thermocople element cable from field to pannel end?

3 Answers  

---

what is the difference between transmitter and smart transmitter ?

4 Answers   Aditya Birla,

---

If mVolts can drop by resistance of wire as compare to mA, then how thermocouple mV reaches in CCR as accurate value?

7 Answers  

---

TCD Principle

1 Answers  

---

---

why we use by pas on a positioner? When can a by pass be not used on a positioner ?

2 Answers  

---

How to convert ma to mv? Resistance 250 ohm is connected in series or Parallel?

3 Answers   ISRO,

---

1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.

0 Answers  

---

Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?

0 Answers   ISRO,

---

If you SOURCE your outputs from a PLC, would you have to make the output HIGH, or LOW, in order to switch an output ON?

1 Answers  

---

what is sequence table in DCS . make a logic in sequence table for tripping of ID fan in Boiler(in YOKOGAWA CS 3000 DCS).

1 Answers   Yokogawa,

---

What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.

0 Answers   TNPL,

---