is it fair to recruit another prestressing agency once earlier agency has provided guide cone for post stressing the Concrete -I girders? It is observed that the bearing plate of another agency is not matching with the earlier one resulting in protruded strands after stressing from the face of girder. Kindly advice.

0 Answers  

---

How much steel required in 1 square feet slab?

12 Answers   Kalika Steel,

---

what is the price of a cubic meter of concrete on international market?

0 Answers  

---

how to calculate 1:1.5:3 ratio concrete cement, sand, metal and water please give me brief calculation

5 Answers   DLF, Sobha Developers,

---

Could you please give me an answer to the mixing proportion of concrete M1 grade (sterngth of 1 MPa)?

0 Answers   L&T,

---

---

What are the structural steel & where they are used

1 Answers  

---

What are the main reasons for conducting pull-out tests for soil nails?

0 Answers  

---

What is the use of offset command?

0 Answers  

---

What is the difference in design between Working Stress method & Limit State Method ? Briefly Explain.

1 Answers  

---

what means if slump is less than 25mm and greater than 80mm?

7 Answers  

---

What is construction mitigation management?

0 Answers  

---

In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.

0 Answers  

---