Answer / k.prakashchandra

Creep is slow continuous rotation of the disc at no load, with potential coil energized.

Answer / souvik

In materials science, creep (sometimes called cold flow) is the tendency of a solid material to move slowly or deform permanently under the influence of mechanical stresses. It can occur as a result of long-term exposure to high levels of stress that are still below the yield strength of the material. Creep is more severe in materials that are subjected to heat for long periods, and generally increases as they near their melting point.

why rating in KVA and KVAR?

4 Answers  

---

what is back emf?

4 Answers   Bhel,

---

In case of 3Phase Supply, Voltage R-Earth/Neutral - 220 Y-Earth/Neutral - 220 Z-Earth/Neutral - 220 Total is -> 660Volts Then Why it is said that 3Phase supply is 440

6 Answers   Hindustan Unilever Limited,

---

What is Exact meaning for Full load Efficiency and Maximum Efficiency of Transformer? Is there any Difference between? If yes ,please provide with formulae?

2 Answers   Techno Labs,

---

A low wet bulb temperature indicates

0 Answers   Caterpillar,

---

what is the total power generation in india?

0 Answers   GUVNL, HAL,

---

Explain the Term in CT Name Plate – Class: 5P10

6 Answers  

---

when a primary current injection test is required, it is accomplished by what?

3 Answers  

---

what is recommended breakdown voltage of transformer oil?

5 Answers  

---

what should be correct gas pressures to be a 1.5 ac unite

0 Answers   DDK,

---

How to design CT for connected with Transformer OLTC operation? normally CT output design for 1A/5A range but during OLTC Tap position changing time how to function the CT?

1 Answers   HEG,

---

why the earth terminal in three pin top is longer than rest of the two terminal and of bigger size?

6 Answers   BARC, MAHINDRA,

---