Answer / ajinkya

I expect that the company should notice hard workers and reward them appropriately to enhance their work. And as far as my carrer is concerned, I would like to be a part of your firm and serve it as long as possible.

what is charger supervision and control supervision?

0 Answers  

---

Is it possible to interlock between ACB & MCCB?

2 Answers   Areva,

---

Dear Sirs, I am a technical persons.In one of our Electrical Sub- Station, We have installed three numbers of 1250KVA ,11KV/0.415KV Transformer to feed the Factory load. We have found some abnormality. In one of our Transformers the leakeage current from transformer body to earth through earth continuity wire is almost 86 Amp but in other transformer it is (5-10)Amp. where the load current on three phase and neutral are respectively 1360Amp,1400Amp,1370 Amp & 176Amp. So please any technical person help me about the reasons of this situation and how I can rectify the fault. Moreover,I have measured the earth resistance of the Earth continuity wire which is less than 1 Ohm. Thanks Tapas Barua

3 Answers  

---

Dear all i want to know FEWA Electrical Supervisor Licence test Previous Year Questions ? If any body know please send to me shibin_75@yahoo.com

1 Answers   FEWA,

---

WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT

0 Answers   Infotech, InTech,

---

what does the regenerative braking mean?and how it used for Dc motor? thanks.

2 Answers  

---

I want to ask a question which i faced during testing of Capacitive Voltage Transformer in AIS. We have measured the C1 , C2 individually , but when we start to measure the total C1+C2 , the testing equipment shuts down and says low loading. Kindly is it possible to find the total capacitance by using measuring device. kindly briefly explain the procedure.

0 Answers   AIS,

---

What is the difference between LT & HT Cable

4 Answers   ETA,

---

if neutral earthing is weak of a system then how can we improve it ? Technically explanation ??

1 Answers   CS, L&T,

---

what is the effect of power factor to (a) voltage (b) transformers (c) generators (d)transmission lines

4 Answers  

---

How does the slip regulator works as a startor

0 Answers  

---

The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?

0 Answers   PGVCL Paschim Gujarat Vij Company Limited,

---