1.How much strength will be attained for M30 grade of
concrete after 28 days?
2.Is it attain 30 N/mm2 or target mean strength?
Answers were Sorted based on User's Feedback
Answer / bidyut dey
1.after 28 days it will be attained 30 N/MM2
2.Terget mean strength
Is This Answer Correct ? | 28 Yes | 4 No |
Answer / ganaaji harsha
M30
Target strength for mix proportioning
f’ck = fck 1.65 s
Where
f’ck = Target average compressive strength at 28 days,
fck = Characteristic compressive strength at 28 days,
s= Standard deviation
From Table 1 standard deviation, s = 5 N/mm2
Therefore target strength = 30 1.65 x 5 = 38.25 N/mm2.
Target Mean Strength for M30 ( IS 456)
Fck 0.825*Standard Deviation
30 0.825*5
34.12
Is This Answer Correct ? | 15 Yes | 1 No |
Answer / chandrasekhar j
1.30 n/mm2
2.it is target mean strength
Is This Answer Correct ? | 11 Yes | 7 No |
Answer / shubham singh
1: M30
Target strength for mix proportioning
f’ck = fck + 1.65 s
Where
f’ck = Target average compressive strength at 28 days,
fck = Characteristic compressive strength at 28 days,
s= Standard deviation = 5 (IS 10262:2009, table 1)
From Table 1 ( IS 10262:2009, Clause 3.2)
f’ck = 30 + 1.65 * 5
= 38.25 N/mm2
2: It should attain target mean strength
Is This Answer Correct ? | 2 Yes | 1 No |
Answer / aditya mayekar
1.after 28 days it will be attained 30 N/MM2
2.Terget mean strength
Is This Answer Correct ? | 2 Yes | 3 No |
Providing cement based water proofing treatment to terrace (Indian water proofing) with brick bats with cement morter (1:5) and (1:3). what are rate in cum or sqm.
how to calculate the quantity of bricks
what is mean by centrifugal force which is act in vehicle on superelevation of road?
what is modular brick and it size
24. Why should we hire you?
Is there any possibility of changing in dia of bar from lower to higher (i.e Lower dia bar at bottom and Higher dia bar at top)
What is the cost of shuttering per Sqm.? How it is calculate by thumb rule...?
What is the quantity of metal 1 & metal 2 to be used in 100 cft concrete?
what is the difference between factor of safety and partial safety factor.??
what is mean by reestimation?
0 Answers Ste Infrastructure Pvt Ltd,
When was the first motorway built in england?
What is the dimension of Slump cone which is used to measure the Slump value of concrete? Slump value for Pile concrete? Slab concrete? Column concrete?