Answer / satypaty

Incomer panel works as incoming source in control supply.
Its not necessary to take PT in Incomer feeder.in some cases typical feeders eg.BPT,LPT are used for PT. Incomers PT are used to gives the auxillary supply to meters and relay.

why are we adopting 132kv,220kv for transmission rather than using 440kv at all transmission lines as it gives lower losses?

2 Answers   APGenco,

---

what is a breaker fail relay

0 Answers   Eskom,

---

why we are using the ac supply in domestic purpose, why don't use dc supply.

5 Answers  

---

WHAT IS THE USE OF STARTER AND CHOKE IN TUBE LIGHT?

1 Answers   Siemens,

---

What does ampere turns shows?

0 Answers  

---

there is a line fault some where on the ove head distribution line. how will i locate the fault for clearing it? ofcourse i have to megger the line but what information makes me clear that the fault is in that section of the line?

2 Answers  

---

why protection and metering CT's are always connected in star why not in delta?

5 Answers   Reliance,

---

How does a television work?

0 Answers   Siemens,

---

why we cant use AC supply products in DC supply?

21 Answers  

---

which connection is safer series or parallel?usually which connection we prefer at home?

5 Answers  

---

What is the technical formula to calculate the load taken by a motor in Amperes ?

2 Answers  

---

Dear Sir / Madam, Actually we requied 64 A MCB, But i have 32 A MCB = 2 No's this two i have to make series connection and we usw any place? isit possible or not......

4 Answers   Hindustan Unilever Limited,

---