Answer / vg

tricky Question.
say we have two sides once we stand facing the transmision
line.you need to find which side is the generation station
so the other side will be the load side.so the power is
transfered from generating to load

Answer / k.prakashchandra

No way

Answer / shabeer ahmad

It is possible always sign marks are fixe at the incomer
side.

Answer / goutam roy

We can't see the flow of electric current and also the electric pressure so without marking the direction of G.S.&S.S How can you tell that , where is the source point& where is the load point, only with seeing?

Answer / abhishek dwivedi

I Just try to give the answer, if we want to see where the power transmitted it means from generation end to distribution end, then it can be check thru waves of stand water pond where there is no wave but if high transmission line route distributed from its top side then there will be waves in water, witch can mean of power flow.

how much speed will trawiling current

3 Answers   TCS,

why do we use LPF wattmeter not UPF in the experiment of no load and blocked rotor test of 3phase slipring induction motor?

3 Answers   Matrix,

What are the essential characteristics of signal flow graphs?

0 Answers  

why the vfd motor take current high in vfd panel then mcc panel.current in vfd panel=160A in 93%.and mcc panel it shows 130A. (132kw motor)

1 Answers  

What is the reason for using a GE G101 MCB in place of an EP102 MCB if both are capable of AC circuit protection?

0 Answers  

how do you test the capacitor bank ?

12 Answers   Essar,

in ac system the current wave form becomes zero for every half cycle then how can we get continuous supply can any one answer to this plsss

2 Answers  

How to measure 20 hp motor resitance

1 Answers  

why in india the voltage generate multiply by 11,,,like 220v,440v,11kv,33kv,66kv,220kv,

3 Answers   NTPC, Servotech, Tata Power,

how step up transformer step up the voltage and what is the reason behind it?

3 Answers  

why the electrolyte level in lead acid battery is maintained 2.5 cms above electrodes?

0 Answers  

In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.

0 Answers