why the vfd motor take current high in vfd panel then mcc
panel.current in vfd panel=160A in 93%.and mcc panel it
shows 130A. (132kw motor)
Answer / prasanna kumar
motor running with star-delta starter or DOL will show full
load of the motor unless the motor drawing high currents due
to faults.while coming to the vfd motor may run at high
speed or low speed acc to the requirement.when it was
running with high speed it will draw more current.
Is This Answer Correct ? | 1 Yes | 1 No |
i am completed my degree(B.E EEE) 2014 anychance to get electrical licence plz help me
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
HAI,HOW TO SET THERMAL OVERLOAD RELAY FOR DOL STATRTER FEEDER AT START AND RUNNING?
what are the available sizes of pin type terminal lugs in the market today?
how the CT and PT is connected in the circuit during testing of transformer explain with diagram
Difference between stepper motor & induction motor.
what is the diffrence between current transformer and voltage trasformer
Interchange 7 and 6 ,÷and× 36×7+4-7×3
what will happen if i connect or change line with phase terminal
What is the comparison of PILC and XLPE cable
In a d.c circuit, if current and resistance are known, power (P=I*I*R) can be determined. This relationship also applied to an a.c circuit. Comment the reason for this.
what is power factor for any engineering equipment?? what should be its value?