In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
No Answer is Posted For this Question
Be the First to Post Answer
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
which turbine has high thermal efficiency a)open gas turbine b)close gas turbine
How one may guess the direction from which the distribution line is incoming if there is no pole plate on poles?
Why earthing done?
Why the transmision line are 11,33,63,132kv?
What will happen if we give 220v supply on both sides to the bulb
7 Answers Exide, Sumeet Industries, Toshiba,
How many earthings are required for motors?
HOW TO CALCULATE ELECTRICAL, MECHANICAL,& OVERALL EFICIENCY OF GAS ENGINE POWER PLANT
why dont we connect the two 12 V DC batteries in parallel, for an inverter (UPS)? is there any harm ?
Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.
how does damper winding produces torque in synchronous motor?
what is booster? and how it is connected in a circuit?