Answer / amit

level transmiter(DP transmiter) Consists of a pizoelectric
material which is a resistive material i.e as the pressure
is applied on it the change in dimension takes place, this
application is used in level measurement differential
pressure is applied,from upper tapping point to the
transmition, this end called High tapping point at the
transmitter which is maintained at high pressure so that at
low tapping point will cause changes as the change in level
occurs this level acts as pressure on pizoelectric material
so this causes change in dimension of material which is
electriacally converted into mA by Bridge and transmitted
to the control room.

WHAT IS THE Differance b/w on/off & pid control valve?

10 Answers  

---

what is the difference between -24 : +24 & 0:24 and where it use?

0 Answers  

---

1 > HOW TO MEASURE INTERFACE LEVEL 2 > DIFFERENCE BETWEEN RADAR & ULTRASONIC LEVEL TRANSMITTER

3 Answers   Atul Auto,

---

hi this is noor in my work spot, i arranged THERMOCOUPLE in the place of RTD. (in FEED WATER tank). can i use T/C or not?

10 Answers  

---

What is the cascade control

0 Answers  

---

Consider a control valve action,the inlet air pressure is only 6 ksc but physically how it can be operate against 100 ksc line fluid pressure?

2 Answers   SCS,

---

hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q

0 Answers  

---

what the pid setting in controller

2 Answers  

---

what is function test.

1 Answers   Takreer,

---

SIR MAY I KNOW IF RADAR TYPE LEVEL TRANSMITTER SHOWING IN THE FIELD 0 % LEVEL AND IN DCS SHOWING 100% THEN WHAT IS THE CAUSE I CLEAN THE CHAMBER & TAKEN ONLINE BUT ONLY ONCE ITS BECOME ZERO IN DCS BUT AGAIN 100% SHOWING IN DCS,THEN I REMOVE THE POWER SUPLLY AND CONNECT IT AGAIN .IS IT OK BUT STILL IN THE DCS ITS 100% AND ON THE DISPLAY ITS INITILAZIATION PLEASE HELP ME READRING THIS?

4 Answers  

---

How to measure high frequency using thermistor

1 Answers   DRDO,

---

When a field input to plc is coming from 400 to 600 meters and the input is in 24 V DC? So signal cable of which cross section i should select for proper signal to plc?

5 Answers   Exxon Mobil,

---