Answer / ramesh

the lighting load is decided not just by the size of the
room but by considering various other factors like the
illumination level requiredin the room, which can theb
converted into electrical power by back working the number
of lamp and the lumens per watt of that chosen type of lamp.

As regarding power load, what i understand is it consists
of airc-conditioning. The thumb rule is 1.5 tonnes of air-
conditioning is required for a room of size say 10 ft x 10
ft x 10 ft. Normally 1.0 tonne ac plant will consume about
2.0 kw max. A 165 litre capacity domestic refrigretaor may
consume about 0.2 kw

For the other power loads like gadgtes (may be xerox
machine at office, computers, printers etc.,) we have to
sum up the actual name plate ratings.

Answer / ayyappan

lighting load is nothing but a load without motor principle,except fan.at the same time power load is the load all motor and induction load..eg:pump motor, grinder,washingmachine, ac etc
for area we calculate the lighting load by illumination in candela.it also depens glare ,beam angle.
for power load its depends on the no of phase,for area means its like machine occupied by the area.

Answer / rm

You can calculate based on lighting load density factor.. which depends on the type of occupancy.... let's say 15w/m2 500m2 Then calculate 500x15 = 7500w.each lighting point will b assumed to have 100w/unit. So 7500/100= 75 lighting points

give some advantages and disadvantages of combiniing the session, presentation, and application layer in the osi model into one single application layer in the internet model

0 Answers  

---

Why secondary of a CT in a power system acts as an open circuit after core saturation?

2 Answers  

---

A system absorbs 100 k J of heat and the increase in its internal energy is 100 kJ; the work done is

0 Answers   Caterpillar,

---

Difference between ac parallel circuit and ac series circuit?

0 Answers  

---

what are the materials used in HRC fuse

3 Answers   Bhel,

---

---

1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor

0 Answers  

---

what is ceiling voltage in an exciter?

1 Answers   KEPCO Energy Service Company,

---

Hi friends, i m electrical engineer i want a cdr for migration purpose so anybody have information about this then send me on jayesh_ee88@yahoo.com.please try to me

0 Answers  

---

WHY HOLDING CONTACTOR OF MOTOR STARTER IS CALLED NO VOLT COIL.

3 Answers  

---

What is Electricity?

2 Answers  

---

why we +ve load distribution in 24v and -ve load distribution in 48volt in the telecom sector.?

2 Answers  

---

sir pls tell me . our ct specifications are 120/5 ,2 core , 0.2 and 5p10 class , 30va and 30va buden. insted of 30 va i want use 15 va. can i use?

0 Answers  

---