How to calculate the lighting load & power load requirement
by knowing area of building/room. Is there any thumb rule?
- 3 Answers
- 17986 Views
- I also Faced
- E-Mail Answers
Answer Posted / ayyappan
lighting load is nothing but a load without motor principle,except fan.at the same time power load is the load all motor and induction load..eg:pump motor, grinder,washingmachine, ac etc
for area we calculate the lighting load by illumination in candela.it also depens glare ,beam angle.
for power load its depends on the no of phase,for area means its like machine occupied by the area.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
how to calculate voltage drop and followed by cable calculation?is there avail in formula?
How to use computer cpu ups use for home inverter circuit board
How to design the earth grid for lightning protection in an industry
what are factors to be consider in electrical installation like load factor,diversity factor .....
If I want to connect a capacitor bank on the HT side of a 11kV/415V, 3 phase delta-star distribution transformer to supply Reactive power to it..what practical specifications of a Capacitor bank that can i've??please reply..
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
draw vector diagram and +ve,zero sequence diagram of symmetrical three phase fault.
what is the difference b/w UHVDC and HVDC(LIGHT)?
what is the constructional difference between a power transformer and potentian transformer?
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m
how many synchronous motor are there in any power plant
How can i get my certificate of competency as an electrical supervisor? I have complicated my B.Tech from Uttarakhand technical university this year (2012).
