How to calculate the lighting load & power load requirement
by knowing area of building/room. Is there any thumb rule?
- 3 Answers
- 17988 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramesh
the lighting load is decided not just by the size of the
room but by considering various other factors like the
illumination level requiredin the room, which can theb
converted into electrical power by back working the number
of lamp and the lumens per watt of that chosen type of lamp.
As regarding power load, what i understand is it consists
of airc-conditioning. The thumb rule is 1.5 tonnes of air-
conditioning is required for a room of size say 10 ft x 10
ft x 10 ft. Normally 1.0 tonne ac plant will consume about
2.0 kw max. A 165 litre capacity domestic refrigretaor may
consume about 0.2 kw
For the other power loads like gadgtes (may be xerox
machine at office, computers, printers etc.,) we have to
sum up the actual name plate ratings.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
why the active power flow of some line is increased when the active power of out is cut ?
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?
what is the min and max ohmic resistance for the earthing rod installed for lighting poles for street light network
What are the different power system losses and how can it be eliminated?
What is the fault or needs to be done when frequency in ac drives is not changing?
state the working of discharge lamp?
What will happen if the armature resistance is in minimum position and the field resistance is in maximum position while starting the motor
what are the assumptions made in swineburne's test?
why ups rating in kva? and why ups are in parellel?.why isolation transformer is used in ups?
How to select HT/MV cable size ?
With a phasor diagram show the effect of increasing the field current of a generator supplying a constant real power and connected to a grid system.
what is the reactance,capacitance & impedence electrical armoured & unarmored Cables.
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
Define peak overshoot.
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
