Answer / sunil patwal

Yes, One vfd is possible to connect two induction motors at
the same time but VFD selection is depand on motor rating.

Answer / kunal salunkhe

It depends on the power rating of the power semiconductor
components used in VFD. Ideally the logic board which are
DSP based in most cases can be used to trigger two sets of
the power semiconductor converter circuits. but the power
semiconductor devices ratings decide whether you can connect
two motors to it or not.

why after termination of HT cable armoured earth connected one end, why not connect other end.pls tell me correct answer.

3 Answers  

---

How to calculate the phase to phase clearness of HT /// LT bus bar?????

0 Answers  

---

if we give DC suply to the AC motor what hapen

5 Answers   TATA,

---

Why neutral is used in electrical system?

2 Answers  

---

how calculate gd2 of ht motors

0 Answers   Hindustan Copper Limited,

---

---

Refernce currents are to be generated using refernce cueernts how can this be done??

0 Answers  

---

what is the minimum distance between substation wall and LT panel outer surface?

3 Answers   L&T,

---

If 24 KVA AVR having Input voltage 200-400v, Output voltage 415+-1%, what will be the voltage if Load is 13A.

0 Answers   Sterling Wilson,

---

they conducted technica for 1 hour..i also managed..they selected 5 boys and only one girl,myself got wait listed.whether they would call or not

2 Answers   MAHINDRA,

---

why capacitors cant used in genset to maintain power factor..??

2 Answers  

---

why white color LED light is not possible?

1 Answers  

---

During he starting up of the motor, the upstream's MCCB (350A) always trips due to the UVT relay activated. Can Star-delta starter use for a 20kW Motor (For a powder mixer machine) cause voltage-dip in the supply line voltage? If so, what are the recommended solution to eliminate/reduce the transient voltage dip in the line voltage?

4 Answers  

---