how to calculate the bus bar current rating

Answers were Sorted based on User's Feedback



how to calculate the bus bar current rating ..

Answer / sunil ulange hit

Bus Bar current rating is calculated Depending upon cros
section area, Lenth, Voltage

Is This Answer Correct ?    40 Yes 3 No

how to calculate the bus bar current rating ..

Answer / virrendra

Bus Bar current rating is based on amount of Current to be
carry. The current carring capacity is 1A / Sq.mm & 1.6A/
sq.mm for Aluminum & copper respectively.

Ex if the 200 Amp load is required to be carry then the (20
x 10 MM ) Aluminum strip is required & the same way (25 x
5 MM ) copper strip is Required.

ofcource the length is also play a little part in this

Is This Answer Correct ?    38 Yes 14 No

Post New Answer

More Electrical Engineering Interview Questions

Before i went to bed my master bathroom lights were working fine. At 2 am, when I went to use the lights, none of them were working. The outlets throughout the bathroom work, but the lights and fan above the toilet don't. I have two panels of switches. The one panel has four switches. One of the switches turns on the hall light, and that works. The other three are to other lights, and they don't. The other panel has three switches. One of those is to the fan, and the other is to a light above the toilet. The other is a to light that is also on that other panel. I tried the breakers, and the one that turns off the outlets, marked for the bathrooom, turns on and off the outlets. None seemed to be tripped. I checked the lightbulbs, and they are fine. Please help

2 Answers  


How to design the no. of ceiling fans required in 5mtr X 10 mtr X 3 Mtr hight room?

0 Answers  


why dc did not flows to earth?

2 Answers  


difference between brush less & brush excitation in a generator?

1 Answers  


Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed

0 Answers  






In a star(primary) to delta(secondary) transformer,how you take the neutral point?

3 Answers   HLL,


WHAT IS THE DIFFERENCE BETWEEN VOLTage and potential diff

5 Answers  


what is the most permissible winding temp when we conducting a generator load test?(condition no load)

0 Answers  


What is the difference between INVERTER and UPS?

7 Answers  


Why let through energy not considered for ACB breaker while cable sizing?

0 Answers  


What is MS-EXCELL?

0 Answers   NTPC, Siemens,


what is the importance of earthing system on the generators big capacity and small?

0 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)