if we supply DC power to AC transformer then what its result?

Categories >> Engineering >> Electrical Engineering
Suggest New Category

Question Posted / himanshu mishra

15 Answers
17802 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

if we supply DC power to AC transformer then what its result?..

Answer / alok ranjan

when dc supply is given to the transformer momentary emf will be generated at the secondary side and will collapse suddenly.
because flux does not change periodically due to dc supply.it changes only when it is switched from off to on or on to off.

primary coil may burn but Burning or not burning of primary depends on design consideration whether it can carry current according to applied voltage or not.because for dc,inductance will be zero so resistance of primary will be less than ac impedance, so current and I^2R loss will increase.

Is This Answer Correct ?

0 Yes

0 No

if we supply DC power to AC transformer then what its result?..

Answer / alok ranjan

I am sorry, by mistake I posted one ans. three times. I request to admin please delete any two.

Is This Answer Correct ?

0 Yes

0 No

if we supply DC power to AC transformer then what its result?..

Answer / mintuk1@gmail.com

We know that transformer coil is highly inductive and low resistive.so if we apply the dc voltage in primary coil then a heavy current flows to the coil .that causes a heating effect produce .by this heating transformer coil may burn .for this reason we do not apply dc on transformer coil .

Is This Answer Correct ?

0 Yes

0 No

if we supply DC power to AC transformer then what its result?..

Answer / john

Definately the transformer winding will burn.

Is This Answer Correct ?

0 Yes

2 No

if we supply DC power to AC transformer then what its result?..

Answer / william lobo.

Real electrical engineers or electricians will not take
such risks. Most electrical equipment is very costly and as
electrical personnel it is my sincere request not to play
with electrical equipment but respect it and take all
correct steps to ensure that proper tests are done before
any switching on is done. My one policy is an electrician
can check 10times but mistake takes place only once. BOOM.

Is This Answer Correct ?

1 Yes

5 No

Post New Answer

More Electrical Engineering Interview Questions

what is meant by flywheel and its role in retardation test

0 Answers

Difference between earthing & grounding.?

3 Answers ABB,

how to set the time in digital timer ?

0 Answers

What is the difference between ACB & MCCB?

7 Answers

What is the difference between in Fourier series and Fourier Transform. and please tell me the difference between both of them and the why we use them in communication system?

0 Answers

differnce between single acting and double acting solenoid valves

0 Answers

what are the types of sus station ?

13 Answers NTPC,

Tell me the reason of connecting domestic t/f primary in star or delta,and also secondary side.

0 Answers

Define norton equivalent circuit?

0 Answers

Electricty is generated at around 16kV, then step up to 220kV for transmission then steped down to power transformers then DTs and then through the LT n/w it reaches the consumer end. At the consumer end 230V supply is required. So, why is electricity not generated directly at 230V and transmitted?

4 Answers

WORKING PRINCIPLE OF VACCUM CKT BREAKER ?

2 Answers

What are the disadvantages of autotransformer?

0 Answers

For more Electrical Engineering Interview Questions Click Here